Epson Stylus Photo R1800 - Setting the Parallelism Adjust Bushing; Setting the Adjustment Gauge; Moving the Carriage Unit

EPSON Stylus Photo R1800/R2400 Revision B
Adjustment Adjustment 140
3. Load unused Ink Cartridges of all colors into the Carriage Unit.
4. Loosen the screw that secures the Parallelism Adjust Bushing.
5. Turn the Parallelism Adjust Bushing upward to match the frame edge and
the bottom of the Parallelism Adjust Bushing gear.
Figure 5-5. Setting the Parallelism Adjust Bushing
6. With its conductor connection portion up, set the Adjustment Gauge in the
specified position (on the left side of the Front Paper Guide).
 Setting Position
Rear direction: Match the rear end of the Gauge with the Driven Roller
Shaft of the Upper Paper Guide.
Left direction: Release the left end of the Gauge from the Tab on the
Front Paper Guide in Figure 5-6
Figure 5-6. Setting the Adjustment Gauge
7. Move the Carriage Unit onto the Adjustment Gauge.
 Moving position: Match the left end of the Gauge with the left end of
the Carriage Unit.
Figure 5-7. Moving the Carriage Unit
C A U T I O N
When the Parallelism Adjust Bushing is turned upwards, the
frame rises up and PG narrows. Make sure that the frame
does not come into contact with the Print Head when
performing the following procedure.
Parallelism
Adjust Bushing
Positioning Point Screw
Parallelism
Adjust Bushing
Positioning
Screw
Setting Position
Conductor Connection Point
Tab
Setting Position