EPSON Stylus Photo R1800/R2400 Revision B
Disassembly And Assembly Disassembly 78
8. Lift the Upper Housing in the direction of the arrows, pull the Guide Pin on
the Upper Housing away from the notch on the printer cover, and remove
the Printer Cover.
Figure 4-10. Removing the Printer Cover
4.2.1.5 Lower Housing and Printer Mechanism
1. Remove the Upper Housing. See Section 4.2.1.4 on page 76.
2. Grip both ends of the two Ink Tube Fasteners with your fingers, slide them
in the direction of the arrows, and draw out the Waste Ink Tubes from the
two Ink Tubes.
3. Remove the four C.B.P. M3 x 10 screws and two C.B.S. (P2) M3 x 10
screws that secure the Printer Mechanism.
4. Hold the Printer Mechanism by its handling positions with both hands, and
remove it from the Lower Housing.
Guide Pin on the Upper Housing
Upper Housing
Printer Cover
Notch on the Printer Cover
C A U T I O N
If you hold the Printer Mechanism at locations other than the
handling positions when performing the following
procedure, the frame might become deformed. Be sure to
hold the Printer Mechanism by the positions.
Figure 4-11. Handling the Printer Mechanism
Handling Positions
To Next Page
Loading...
