Epson Stylus Photo R1800 - Page 214

EPSON Stylus Photo R1800/R2400 Revision B
Stylus Photo R2400 Overview 214
Table 8-11. Troubleshooting of Paper Mismatch Error
Occurrence
Timing
Phenomenon Detail
Faulty Part/Part
Name
Check Point Remedy
At operation When feeding a Board
Paper, an error is displayed
on the LED and EPW3.
Paper EJ Frame
Assy
1. Check if the CD-R Tray Base(Board Tray Base) is closed
or not.
1. Open the CD-R Tray Base(Board Tray
Base) .
CD-R Sensor
(Board Sensor)
1. Check that the Connector cable of the CD-R Sensor is
securely connected to the connectors of the CD-R Sensor
and Panel Board.
1. Connect the Connector cable of the CD-R
Sensor (Board Sensor) to the CD-R
Sensor(Board Sensor) and Panel Board
Connectors.
2. Check the CD-R Sensor(Board Sensor) or Connector
cable for damages.
2. Replace the CD-R Sensor(Board Sensor)
with a new one.
Panel Board connector
Connector cable of
the CD-R Sensor
CD-R Sensor
Table 8-12. Troubleshooting of Ink Low
Occurrence
Timing
Phenomenon Detail
Faulty Part/Part
Name
Check Point Remedy
At operation or
during printing
A message is displayed on
the LED and EPW3 during
printing.
Ink Cartridge 1. Look at the remaining ink indication of the EPW3 to check
the amount of the ink remaining in the Ink Cartridge.
1. Prepare a new Ink Cartridge.
Table 8-13. Troubleshooting of Ink Out Error
Occurrence
Timing
Phenomenon Detail
Faulty Part/Part
Name
Check Point Remedy
During printing After the Carriage has
detected the HP, an error is
displayed on the LED and
EPW3.
Ink Cartridge 1. Look at the remaining ink indication of the EPW3 to check
whether the ink remains in the Ink Cartridge.
1. Replace the Ink Cartridge with a new one.