Epson Stylus Pro 4400 - Page 163

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Troubleshooting Troubleshooting Based on Panel Messages 163
 Recovery
nnnn Cause Replacement part/unit
Remedy
(how to recover errors)
0002
The number of CR movement cycles has
reached predetermined value.
Refer to "SERVICE REQ. 00000101 (p.175)." Refer to "SERVICE REQ. 00000101 (p.175)."
0008
RTC backup battery shut off / uninstalled RTC backup battery Replace RTC backup battery, turn on the printer in Maintenance Mode 2, and execute
"RTC&USB ID&IEEE1394 ID" to set the date using basic adjustment in adjustment program.
0040
Pump counter has reached predetermined
amount.
 Box Assy., Flushing
 Pump Unit
 Cleaner, Head, A, ASP
 Porous Pad, Box, FL, Upper
 Porous Pad, Box, FL, Lower
Replace parts/ units listed in the left column, and execute “Reset When Cleaning Unit Change”
using Reset Counters in adjustment program.
0080
Date is not set
---
Turn on the printer in Maintenance Mode 2, and execute “RTC&USB ID&IEEE1394 ID” to set
the date using basic adjustment in adjustment program.
0088
RTC backup battery is not installed.
---
Install RTC battery, turn on the printer in Maintenance Mode 2, and execute “RTC&USB
ID&IEEE1394 ID” to set the date using basic adjustment in adjustment program.
0100
RTC backup battery pressure is temporally
low.
---
Wait for a while.
0200
The number of ASF paper feeding has
reached predetermined value.
 Roller Assy, LD, Right
 Roller Assy, LD, Left
 Mount Assy., Plate, Motor, ASF, SP
Replace parts/ units listed in the left column, and execute “Reset ASF Counter” and “Reset
Paper ejection switching / PG switching counter” using Reset Counters in adjustment program.
C H E C K
P O I N T
Replace the following parts when replacing the Cleaning Unit.
BOX ASSY.,
FLUSHING
PUMP CAP ASSY
CLEANER, HEAD, A, ASP
POROUS PAD, BOX, FL, UPPER
POROUS PAD,
BOX, FL, LOWER