EST EST3X - Enable Menu; Status Menu

Chapter 2: Product description
EST3X Technical Reference Manual 25
Status Menu
Use the commands on the Status Menu to check the status of the system. The
report that each command creates includes both physical points and pseudo
points.
Table 10: Status Menu selection descriptions
Selection
Access level Description
Back
None Returns to the previous menu
Exit Menu
None Returns to the event message screen
All Active Points
None Displays or prints a list of all points that are in an active or
other off-normal state (trouble, disable, etc.)
Alarm
None Displays or prints a list of all active (in alarm) alarm input
device types
Supervisory
None Displays or prints a list of all active supervisory input device
types
Trouble
None Displays or prints a list of all points in trouble
Monitor
None Displays or prints a list of all active monitor input device types
Test
None Displays or prints a list of points in active service groups that
are in the active or trouble state
Disabled
Points None Displays or prints a list of all addressable points that are
disabled
Outputs
None Displays or prints a list of all active output device types and
LED-switch card LEDs
Security [1]
None Displays or prints a list for one of the following:
• Partition: Lists security partitions and shows the selected
partition’s corresponding state
• Holdup: Lists holdup devices and their corresponding
state
[1] Only available when the security control function is enabled in the 3-SDU.
Enable Menu
All components are enabled at power-up unless programmed otherwise. Use the
commands on the Enable Menu to place parts of the system that have been
disabled back into service.