EST EST3X - Led

Chapter 3: Operating instructions
EST3X Technical Reference Manual 75
To enable a control-display switch:
1. Access the Main Menu, and then click Enable.
2. Click Switch, and then enter the panel, card, and device addresses.
3. Enter the access level password.
Disabling and enabling control-display LEDs
To disable a control-display LED:
1. Access the Main Menu, and then click Disable.
2. Click LED, and then enter the panel, card, and device addresses.
3. Enter the access level password.
To enable a control-display LED:
1. Access the Main Menu, and then click Enable.
2. Click LED, and then enter the panel, card, and device addresses.
3. Enter the access level password.
Changing the output state of an LED
Use the Activate command to change the output state of LEDs on a control-
display module. Changing the output state requires entering a command priority
level to one of the following output states:
• Set: Overrides low, medium, and high priority instructions and forces the
device to the desired state. The set priority does not reset the device’s priority
counters.
• Latch: Overrides low, medium, and high priority instructions and forces the
device to the desired state. The latch priority does reset the device’s priority
counters.
• Low Priority: Forces the device to the desired state and adjusts the low
priority counter accordingly.
• Medium Priority: Forces a device to the desired state and adjusts the medium
priority counter accordingly.
• High Priority: Forces a device to the desired state and adjusts the high priority
counter accordingly.
To change the LED output state:
1. Access the Main Menu, and then click Activate.