EST EST3X - Abnormal Points Report; Device Maintenance Reports

Chapter 3: Operating instructions
52 EST3X Technical Reference Manual
• Monitor: Lists all active monitor input device types
• Test: Lists points in an active service group that are in the active or trouble
state
• Disabled Points: Lists all addressable points that are disabled
• Outputs: Lists all active output device types and control-display card LEDs
To access a status report:
1. Access the Main Menu, and then click Status.
2. Click the desired report.
3. Enter the panel address.
4. Click Display and scroll through the list. When finished, click or press the
Acknowledge button to exit the screen.
— or —
Click Print Locally, select the printer, and then click again to exit the screen.
Abnormal points report
Use the All Active Points command on the Status Menu to display or print a list
that includes all points in the system that are not in their normal state.
Note: During normal operation, most points in the system are not active. Points
whose normal state is active are included in the list.
To display or print a list of all abnormal points:
1. Access the Main Menu, and then click Status.
2. Click All Active Points.
3. Enter the panel address.
4. Click Display and scroll through the list. When finished, click or press the
Acknowledge button to exit the screen.
— or —
Click Print Locally, select the printer, and then click again to exit the screen.
Device maintenance reports
A set of device maintenance reports are available to help you determine if any
addressable smoke detector devices require maintenance. Each report gives you