Chapter 3: Operating instructions
78 EST3X Technical Reference Manual
Clearing a guard patrol alarm
When a guard patrol tour ends because a guard patrol station was not activated
at the proper time, the system issues an event message. When a guard patrol
event is generated, you must restore the guard patrol route to clear the alarm. To
determine which stations reported in, view the details of the event (see āViewing
event message detailsā on page 50).
To restore a guard patrol:
1. Access the Main Menu, and then click Restore.
2. Click Guard Patrol Route, and then click the route to be restored.
3. Enter your access level password.
Disabling and enabling a guard patrol group
Disabling the group isolates it from the system just as if it were a hardware
component. The command only disables the group response. When a group is
disabled, the Disable LED indicates and a Disabled Active event shows in the
Trouble Queue.
Enabling a Guard Patrol group establishes it as part of the system just as if it
were a hardware component. When enabled, any changes in state that occurred
while the group was disabled are processed.
To disable a guard patrol group:
1. Access the Main Menu, and then click Disable.
2. Click Group, and then select Guard Patrol.
3. Click the group from the group list.
4. Enter the access level password.
To enable a guard patrol group:
1. Access the Main Menu, and then click Enable.
2. Click Group, and then select Guard Patrol.
3. Click the group from the group list.
4. Enter the access level password.
To Next Page
Loading...
