Chapter 2: Product description
22 EST3X Technical Reference Manual
User access levels
Certain user interface controls and command menu functions are password
protected and have a user access level that is determined by the marketplace
setting. The four user access levels are detailed in Table 7.
Each access level is given a default password that should be changed once the
panel is put into service. See “Changing Access Level passwords” on page 66 for
instructions.
Note: User access for initiating commands times out after a preconfigured period
of time. When the time out setting is reached, the panel reverts to the default
level. The time out period is configured in the 3-SDU and can be set from
00:15 to 99:59 minutes. The default setting is 5 minutes.
Table 7: User access level privileges
Privileges
• Acknowledge function (button)
• Alarm silence function (button) [1]
• Panel silence function (button) [1]
• Reset function (button) [1]
• Event details
• Statuses
• Reports
• Drill function (activate/restore)
• Output selection
• Display/printer selection
• Printer selection
• Toggle language
All default privileges, plus:
• Guard patrol routes (activate/restore)
All default and level 1 privileges, plus:
• Devices (enable/disable)
• Zone groups (enable/disable)
• Remote read lock (activate/restore)
• Remote write unlock (activate/restore)
• Sensor bypass (activate/restore)
• Gas accel response (activate/restore)
• Alternate sensitivity (activate)
• Alternate message route (activate)
• Primary sensitivity (restore)
• Primary message route (restore)
• Change time (program)
• Change date (program)
• Security devices (bypass/unbypass)
• Security partitions (arm/disarm)
• Change password for level 1 (program)
To Next Page
Loading...
