EST EST3X - Changing Access Level Passwords

Chapter 3: Operating instructions
66 EST3X Technical Reference Manual
To restore primary message routing:
1. Access the Main Menu, and then click Restore.
2. Click Primary Msg Route.
3. Enter the access level password.
Changing Access Level passwords
Password protection is used to regulate access to certain user interface controls
and commands. It is recommended that you change the default passwords once
the panel is put into service.
Access level
Default password
1
1111
2
2222
3
3333
4
4444
Note: The user access time out can be configured in the 3-SDU. The default
setting is 5 minutes. When user access times out, the panel returns to the default
level (0).
An access level password can only be changed by a higher access level. This is
referred to as the controlling access level. The access level you want to change
is called the target access level.
To change the access level password:
1. On the Main Menu, choose Program.
2. On the Program Menu, choose Edit Password.
3. Click the target access level.
4. Enter the password for the controlling access level.
5. Enter the new password for the target access level.