EST EST3X - Restore Menu

Chapter 2: Product description
30 EST3X Technical Reference Manual
Selection
Access level Description
Sensor Bypass
2 Keeps the photo element on a SIGA2-PHS Multisensor
Smoke Detector from generating a supervisory message.
Requires a panel, card, and device address).
Gas Accel
Response
2 Changes the carbon monoxide (CO) rate of a CO detector for
testing purposes. Requires a panel, card, and device address.
[1] Requires a 3X-PMI Paging Microphone Interface.
Restore Menu
Use the commands on the Restore Menu to switch outputs and LED indicators
off, and switch sensor sensitivity and event message routing to their primary
settings.
Table 14: Restore Menu selection descriptions
Selection
Access level Description
Back
None Returns to the previous menu.
Exit Menu
None Returns to the event message screen.
Primary
Sensitivity
2 Returns the fire detector sensitivity setting from alternate to
primary alarm sensitivity.
Primary Msg
Route
2 Returns the fire detector sensitivity setting from alternate to
primary message routing.
Guard Patrol
Route
3 Clears a guard patrol alarm.
Relay
3 Restores the output state of a relay. Select one of the states
from the Output Priority Menu. Requires a panel, card, and
device address.
• Set
• Latch
• Low Priority
• Medium Priority
• High Priority
LED
3 Restores the output state of an LED from on to an inactive
state. Select one of the states from the Output Priority Menu.
Requires a panel, card, and device address.
• Set
• Latch
• Low Priority
• Medium Priority
• High Priority