Chapter 3: Operating instructions
EST3X Technical Reference Manual 57
• When you enable a device, all indicators and outputs activated by the device
will reactivate.
To disable a device:
1. Access the Main Menu, and then click Disable.
2. Click Device, and then enter the panel, card, and device address.
3. Enter the access level password.
To enable a device:
1. Access the Main Menu, and then click Enable.
2. Click Device, and then enter the panel, card, and device address.
3. Enter the access level password.
Disabling and enabling option cards
Option cards can include hardware layer cards and modules, and operator layer
control-display modules. Disabling a card isolates it from the system. While the
card is disabled, the EST3X control panel logs the status change signals, but is
prevented from processing the signals until the card is enabled.
The control panel keeps track of how many times you disable a card without
enabling it. You must enable a card the same number of times you disable it in
order to return the card to its original condition.
Option card addresses are listed in Appendix B “Addresses” on page 257.
To disable an option card:
1. Access the Main Menu, and then click Disable.
2. Click Card, and then enter the panel and card addresses.
3. Enter the access level password.
To enable an option card:
1. Access the Main Menu, and then click Enable.
2. Click Card, and then enter the panel and card addresses.
3. Enter the access level password.
To Next Page
Loading...
