Chapter 3: Operating instructions
54 EST3X Technical Reference Manual
The report is structured with the most recent event or instruction listed first. The
report can be displayed for viewing on the LCD screen or printed to a local
printer. The history reports are listed below.
• History with Text: Provides a history of events and operator commands
logged by the panel. For each point that activated or restored, the detail
includes the point’s message text.
• History without Text: Provides a history of events and operator commands
logged by the system. For each point that activated or restored, the detail
includes the point’s device address.
To view a history report:
1. Access the Main Menu, and then click Status.
2. Click Reports, and then click History.
3. Click the desired report and enter the panel address.
4. Click Display and scroll through the list. When finished, click or press the
Acknowledge button to exit the screen.
— or —
Click Print Locally, select the printer, and then click again to exit the screen.
System revisions report
The Revisions report provides system database information, installed card types
and their firmware, bootstrap, and database versions, and system IP addresses.
The initial Revision Report screen shows system information described in the
table below.
Description
Count Shows the total number of times that the panel has gone into alarm since the
alarm history was cleared.
Shows the Marketplace setting configured in the 3-SDU.
Shows the SFS1-CPU Main Board firmware version number.
-SDU Shows the SDU version number.
If a supplementary audio feature is installed, shows the database version
number.
Shows the SDU project (database) version.
To Next Page
Loading...
