EST EST3X - Page 38

Chapter 2: Product description
28 EST3X Technical Reference Manual
Selection
Access level Description
• Low Priority: Forces the device to the desired state and
adjusts the Low Priority counter accordingly.
• Medium Priority: Forces a device to the desired state and
adjusts the Medium Priority counter accordingly.
• High Priority: Forces a device to the desired state and
adjusts the High Priority counter accordingly.
LED
3 Changes the output state of an LED
from off to an active state
or from one active state to another active state. Select one of
the states from the Output Priority Menu. Requires a panel,
card, and device address.
• Steady: Select one of the states from the Output Priority
Menu.
- Set: Overrides low, medium, and high priority
commands
and forces the device to the desired state.
The Set priority does not reset the device’s priority
counters.
- Latch: Overrides low, medium, and high priority
commands
and forces the device to the desired state.
The Latch priority does reset the device’s priority
counters.
- Low Priority: Forces the device to the desired state
and adjusts the Low Priority counter accordingly.
- Medium Priority: Forces a device to the desired state
and adjusts the Medium Priority counter accordingly.
-
High Priority: Forces a device to the desired state and
adjusts the High Priority counter accordingly.
• Fast Blink: Select one of the states from the Output
Priority Menu (see the priority states
described in “Steady”
above).
- Set
- Latch
- Low Priority
- Medium Priority
- High Priority
• Slow Blink: Select one of the states from the Output
Priority Menu
(see the priority states described in “Steady”
above).
- Set
- Latch
- Low Priority
- Medium Priority
- High Priority