Setting Up DSL/IP Tests
334 MAX-635G
Test Configuration
Note: For Ethernet Test Setup, NAT is available only for GVXAA and GVXAB
models.
Login to WAN (Data Test) (in Manual Test Setup only) can be set to
one of the following, when running a Manual Test:
Auto will start the WAN login automatically right after Show Time.
Manual enables a Login button on the WAN Status page, once
Show Time is reached. You must press the button to start the WAN
login.
This parameter can not be selected for the following Access Modes:
Sync Only, Bridged, and IPv6 (DHCP), and will be set to Auto.
The following parameters are available only when Access Mode is PPPoE
or PPPoA.
Login Name/Password is your user ID and password.
Obtain IP is either Dynamic where the access concentrator or
broadband remote access server assigns a temporary IP address to
the unit, or Static where you enter the IP address of the unit.
Static IP is the address of the current location assigned by the
service provider. This entry is available only if Obtain IP is set to
Static.
The following parameters are available only when Access Mode is IPoA or
Static.
IP Address is the address for the unit that is actively connected to
your network or the internet at the time of login.
Gateway is the IP address of the default gateway.
Verify Gateway can be set to Enable or Disable.
Subnet Mask is the network address used to identify if the IP
address is within the same wide area network.
To Next Page
Loading...
