Setting Up DSL/IP Tests
Copper and G.fast/VDSL2/ADSL2+ Multi-play Test Set 333
Test Configuration
Continuous where the test runs until you manually stop it, or
User Defined where you can set a Keep Sync Time Period.
Default is 5 minutes.
VPI (ATM mode only) is the virtual path identifier (VPI) ranging from 0
through 255 for the downstream channel.
VCI (ATM mode only) is the virtual circuit identifier (VCI) ranging from
32 through 65535 for the downstream channel.
Encapsulation Type depends on the network configuration and sets
the ATM to either LLC also known as LLC-SNAP (logical link
control-sub network address protocol) or VC_MUX (virtual channel
multiplex).
VLAN Support enables the unit to tag/untag ethernet frames.
VLAN ID is a virtual local area network (VLAN) tag ranging from 0
through 4094. The entry is available only when VLAN Support is
Enable.
Vendor ID is the name of the unit. This entry is available only when
Access Mode is DHCP or IPv6 (DHCP).
Local Mac Address is the internal MAC address of the unit: either
MaxTester or User Defined.
Mac Address is a specific MAC address, in a hexadecimal format, if
User Defined was selected for the previous parameter. This entry is
available only when Access Mode is DHCP, Static, or IPv6 (DHCP).
WAN Login Timeout is a numeric setup entry.
G.INP allows you to Enable/Disable the standards based Physical
Layer Retransmission scheme for impulse noise protection. This entry
applies only to Auto and Manual tests.
NAT (network address translation) allows you to Enable/Disable the
translation of the IP addresses of computers in a local network to a
single IP address. NAT is available only if Access Mode is set to DHCP,
Static, or IPoA.
To Next Page
Loading...
