Setting Up DSL/IP Tests
332 MAX-635G
Test Configuration
VDSL2/ADSL2+ or VDSL2/ADSL2+ Bonding for V2XAA and GVXAA
units.
VDSL2/ADSL2+ (xA/P2) for V2XAB unit.
VDSL2/ADSL2+ (xA/Pair 1) for GVXAB unit.
Annex J allows you to Enable/Disable this option when Test Interface
is:
VDSL2/ADSL2+ (xB/P1) for V2XAB unit.
ADSL2+ (xB/Pair 2) for GVXAB unit.
ADSL Transport displays the transport type options: PTM (packet
transfer mode), ATM (asynchronous transfer mode), or ATM and PTM.
When G.fast is selected as the Test Interface, ADSL Transport is
disabled.
Access Mode options are dependent on the test setup selection.
For Auto and Manual tests, available options are: Sync Only,
Bridged (not in Auto Test), DHCP, Static, PPPoE, PPPoA, IPoA, and
IPv6 (DHCP).
For Ethernet tests, available options are Bridged, DHCP, Static,
PPPoE, and IPv6 (DHCP).
Note: IPv6 requires an option key to be enabled.
Auto Resync allows you to Enable the SyncLossCounter as the
Pass/Fail criteria. When SyncLossCounter+1 is reached, the test will
have fail status.
If Auto Resync is disabled, any time the test loses sync, the result status
will be fail and the test will stop automatically.
Sync Timeout Period enables you to enter the duration, between
2 and 30 minutes, to run a DSL test from activation to reaching
Show Time.
Keep Sync Time is either:
To Next Page
Loading...
