Setting Up DSL/IP Tests
Copper and G.fast/VDSL2/ADSL2+ Multi-play Test Set 331
Test Configuration
ADSL2+ (xA/P2) - if VDSL2 option disabled, ADSL Annex A mode.
VDSL2-30a (Pair 1) - if VDSL2 option is enabled.
VDSL2 Bonding - if VDSL2 and Bonding options are enabled.
The GVXAA unit does ADSL Annex A on pair 1 and supports bonding.
The Test Interface setup options for the GVXAA module are the
following:
G.fast if enabled.
VDSL2/ADSL2+ - if VDSL2 option enabled.
ADSLMulti supports G.DMT, T1.413, and G.Lite.
VDSL2/ADSL2+ Bonding - if VDSL2 and Bonding options enabled.
VDSL2-35b if enabled.
The GVXAB unit does ADSL Annex B and UR2 which can be configured in
Setup\Modem Settings\DSLAM. ADSL Annex A is on pair 1, and ADSL
Annex B and UR2 are on pair 2. This modem does not support bonding.
Test Interface options for the GVXAB module are as follows:
G.fast (Pair 1)
VDSL2/ADSL2+ (xA/Pair 1)
ADSLMulti (xA/Pair 1)
VDSL2-35b (Pair 1)
ADSL2+ (xB/Pair 2)
ADSLMulti (xB/Pair2)
ADSL2+ (UR2/Pair 2)
ADSLMulti (UR2/Pair 2)
Annex M allows you to Enable/Disable this option when Test
Interface is:
To Next Page
Loading...
