Setting Up DSL/IP Tests
340 MAX-635G
Test Configuration
Throughput Test (GVXAA and GVXAB models only) implements the
iPerf3 or Ookla
1
tool for active measurements of the maximum
achievable bandwidth on IP networks.
Note: Ookla Privacy Policy: http://www.speedtest.net/privacy
You, end user, understand and acknowledge, by performing the test
contained in the Speedtest Powered Software Application, that Ookla, LLC
may collect your IP address during the test and share it with selected third
parties.
Traceroute is a complement tool of the Ping test to determine why a
destination cannot be reached, or where the internet is broken.
Web Browser Test can only be started when a WAN connection
(either through xDSL or Ethernet) has been established.
When enabled, the sub-tests’ test pages are available in the results pages.
You must highlight the sub-test for which you want the contents shown on
the Test Setup page.
Note: Select Tests and Te s t S et up tabs are not available in Sync Only and
Bridged Access Modes.
To select sub-tests:
1. Press the up/down arrows to highlight the desired test.
2. Press the left/right arrow keys to toggle between Enable/Disable.
OR
3. Press on any value to open the list box to toggle between
Enable/Disable.
1. Ookla is a third party provider. The Ookla Speedtest Powered technology involves Ookla owned and/or controlled
servers that may or may not be within your network. Ookla retains the right to aggregate test results and to monetize
aggregated results as they see fit.
To Next Page
Loading...
