Extron electronics CrossPoint 450 Plus Series User Manual

3-59
CrossPoint / MAV Matrix Switchers • Operation
Performing a hard reset — All models
The hard reset function (mode 1 for the sake of comparison with an Extron IPL
product) returns the switcher to the factory default firmware. Event scripting will
not start if the switcher is powered on in this mode. All user files and settings
(drivers, adjustments, IP settings, and the like) are maintained.
N
• After a hard reset is performed, update the switcher’s firmware to the latest
version. Do not operate the switcher firmware version that results from
the mode 1 reset. If you want to use the factory default firmware, you must
upload that version again. See chapter 5, “Matrix Software”, for details on
uploading firmware.
• If you do not want to update firmware, or you performed a hard reset by
mistake, cycle power to the switcher to return to the firmware version that
was running before the mode 1 reset. Use the 0Q SIS command to confirm
that the factory default firmware is no longer running (look for the asterisk
[*] following the version number.
• The hard reset restores the factory-installed firmware. The switcher reverts
to that factory firmware the next time power is cycled off and on unless a
firmware update is performed before the power cycle.
• Ensure that you have backed up any locally-created HTML, JavaScript, or
other files that you have uploaded to the switcher’s user file space before you
perform the hard reset. A hard reset will erase all locally-created files from
the switcher.
Perform a hard reset as follows:
1
. If necessary, turn off power to the switcher.
2. Press and hold the Reset button on the rear panel while you apply AC power
to the switcher (figure 3-84).
Power
RESET
RESET
Press and hold the Reset button while
you apply power to the switcher.
Release the Reset button.
The switcher flashes the front panel
button indicators green, red, and
amber and then turns them off.
Continue to hold the Reset button until all input
and output buttons return to either unlit or to
background illumination and the RGBHV or
Video and Audio buttons turn on.
NOTE
The Reset button on switchers with matrix sizes of 24 x 12 and above
(with the exception of the MAV Plus 248 A and MAV Plus 328 A)
have a different appearance and do not have a rear panel Reset LED.
Figure 3-84 — Hard reset

Extron electronics CrossPoint 450 Plus Series Specifications

General

Brand	Extron electronics
Model	CrossPoint 450 Plus Series
Category	Matrix Switcher
Language	English