Extron electronics CrossPoint 450 Plus Series - File Management Tab; File.management.page

6-11
CrossPoint / MAV Matrix Switchers • HTML Operation
6. Click the Firmware Upgrade link.
7
. Click the Browse button. An Open File window appears.
8
. Navigatetothefolderwhereyousavedthermwareupgradele.Selectthe
file.
N
Valid firmware files must have the file extension “.S19”. Any other file
extension is not a firmware upgrade.
N
The original factory-installed firmware is permanently available on the
CrossPoint or MAV switcher. If the attempted firmware upload fails for any
reason, the switcher automatically reverts to the factory-installed firmware.
9
. Click the Open button.
10
. Click the Upload button. The firmware upload to the switcher may take a few
minutes.
File Management Tab
File Management Page
Todeletelessuchasuser-suppliedHTMLpagesfromtheswitcherortoupload
your own files to the switcher, click the File Management tab. The switcher
downloadsthelemanagementHTMLpage(gure6-9).
Figure 6-9 — File Management page
N
The files listed in figure 6-9 are shown for example only and may not be present
on your switcher.
To delete a file, click the Delete button adjacent to the unwanted file.