Extron electronics CrossPoint 450 Plus Series - Page 154

Matrix Software, cont’d
CrossPoint / MAV Matrix Switchers • Matrix Software
5-16
12
14
13
13
Figure 5-13 — Confirm window
13. Ifnecessary,changetheportnumberinthedeviceporteld:
• RearpanelRS-232/RS-422port,enter1.
• FrontpanelCongurationport,enter2.
Click the OK button. The Firmware Loader reports, “This process could take
several minutes. Please wait...”,thendisplaysastatusbarthatshowsthe
progress of the upload. When the upload is complete, the Firmware Loader
reports “Unit resetting, this can take some time, please wait. ...”,andthen“Transfer
complete!”.
N
Firmware upgrades using either serial port can take several minutes.
14. When the Firmware Loader reports, “Transfercomplete!”,clicktheExit button
on the Firmware Loader and then again on the port configuration window.
TheFirmwareLoaderandtheMatrixSwitchersControlProgramclose.