Table of Contents, cont’d
CrossPoint / MAV Matrix Switchers • Table of Contents
ii
Power ........................................................................................................................................3-12
Creating a configuration .......................................................................................................3-13
Example 1: Creating a set of video and audio ties ..........................................................3-14
Example 2: Adding a tie to a set of video and audio ties ...............................................3-16
Example 3: Removing a tie from a set of video and audio ties ......................................3-18
Viewing a configuration ........................................................................................................3-20
Example 4: Viewing video and audio, audio only, and video only ties ..........................3-21
I/O grouping.............................................................................................................................3-24
Example 5: Grouping inputs and outputs ........................................................................3-26
Setting RGB delay (CrossPoint switchers) ............................................................................3-28
Example 6: Setting the RGB delay for an output ............................................................3-29
Using presets ............................................................................................................................3-31
Example 7: Saving a preset ...............................................................................................3-32
Example 8: Recalling a preset ...........................................................................................3-33
Muting and unmuting video and audio outputs ...............................................................3-35
Example 9: Muting and unmuting an output..................................................................3-36
Viewing and adjusting the input audio level (audio models) ..........................................3-38
Example 10: Viewing and adjusting an input audio level ..............................................3-39
Viewing and adjusting the output volume (audio models) .............................................3-44
Reading the displayed volume .........................................................................................3-45
Example 11: Viewing and adjusting an output volume level .........................................3-48
Setting the front panel locks (Executive modes) ................................................................3-52
Selecting Lock mode 2 or toggling between mode 2 and mode 0 ................................3-52
Selecting Lock mode 2 or toggling between mode 2 and mode 1 ................................3-53
Performing a system reset from the front panel................................................................3-53
Background illumination .......................................................................................................3-54
Selecting the rear panel RS-232/RS-422 port protocol and baud rate ............................3-54
Rear Panel Operations ...........................................................................................................3-55
Performing soft system resets — CrossPoint Ultra
and MAV Plus 88, 128, 816, 164, 168, 1212, 1616, 248, and 328 matrix sizes ................3-56
Performing soft resets — CrossPoint 450 Plus
and MAV Plus 2412, 2424, 3216, and 3232 matrix sizes ....................................................3-58
Performing a hard reset — All models ................................................................................3-59
Optimizing the Audio (Audio Models) ........................................................................3-60
Troubleshooting ........................................................................................................................3-60
General checks .........................................................................................................................3-60
Plasma display S-video problem (CrossPoint switchers) ....................................................3-60
Configuration Worksheets .................................................................................................3-61
Worksheet example 1: System equipment ..........................................................................3-61
Worksheet example 2: Daily configuration.........................................................................3-62
Worksheet example 3: Test configuration ..........................................................................3-63
32-button switchers configuration worksheet ...................................................................3-65
16-button switchers configuration worksheet ...................................................................3-67