118
www.factoryfive.com 508-291-3443
Rear Calipers and Rotors
Push the slotted rotor onto the spindle.
Attach the caliper to the spindle using the OEM T-Bird bolts.
Width Adjustment
Mount your wheels and tires.
Lower the frame off the jack stands.
With the car on the ground, check the ride height of the car to the bottom of the 4” frame rail
Front: 4.25”-4.50”
Rear: Usually 4.75” with one person normally in the car or 5.00” with two people in the car.
Jack the rear of the car up and place on jack stands located on the lower control arms near the shock.
This supports the suspension at ride height.
Remove the rear wheels.
Use a couple of lug nuts on the wheel studs to ensure that the rotor is seated correctly.
To Next Page
Loading...
