182
www.factoryfive.com 508-291-3443
The small aluminum piece packed in the assembly is not used for this application.
Tighten all the remaining hardware mounting the pedal box to the chassis.
Front flexible brake lines
Unpack the hardware from the brake line components.
Lay out the various lengths of brake line so you can see what you have to work with. Like the fuel lines,
there are many ways to run these lines but you must be very careful to keep them protected from moving
parts, heat, or being to close to the bottom of the car.
Which side you run down may depend on where you are hooking up to your fuel rail, carburetor,
or pressure regulator. We usually run the fuel lines on the passenger side of the car and the brake
lines on the driver side of the car.
The laser cut brackets from the front brake assembly attach to the chassis right behind the front upper
control arms. Drill and rivet these in place using two
3
/
16
” rivets.
To Next Page
Loading...
