231
www.factoryfive.com 508-291-3443
Mark the tube where it needs to be cut so that the tube will just touch the attaching location.
Remove the tube from the vehicle.
Cut the tube using a hack saw or if available a cut-off wheel. If necessary clean the end up with tin
snips or a grinder.
Shake and blow the tube out so that no metal pieces are in the tube.
Reattach the tube assembly to the engine and tighten the hose to the radiator.
Lower radiator hose
Connect the lower radiator tube to the engine.
Starting at the radiator, route the lower radiator hose over the top of the steering rack tie rod and under
the steering shaft to the water pump.
Mark the tube where it needs to be cut so that the tube will just touch the attaching location.
Remove the tube/hose assembly from the vehicle.
Cut the tube using a hack saw or if available a cut-off wheel. If necessary clean the end up with tin
snips or a grinder.
Shake and blow the tube out so that no metal pieces are in the tube.
Remount the tube assembly and tighten the hose clamps on the mount locations.
Attach the overflow container to the front “X” using the supplied screws.
Attach the overflow tube and nipple to the overflow tank.
Zip-tie the hose to the corrugated upper radiator hose and run it to the radiator fill adapter.
Fan Wiring
Wire crimp tool
To Next Page
Loading...
