385
www.factoryfive.com 508-291-3443
Hold the mesh up to the rear vent area and mark the outline on the mesh.
Bend the mesh to the shape or use tin snips to cut the shape of the vent.
If bending, cut the depth you would like the mesh to sit at otherwise cut or find spacers and fasteners to
get the correct depth.
Finishing Touches
Alignment Specifications
Take your new car to an alignment shop and have the car aligned properly before hitting the track. A
minor flaw in alignment can cause very “twitchy” handling. Avoid temptation and never drive a car
without proper alignment.
Front
For a car using a manual steering rack or the power rack without power use the following specifications:
Caster: 3
Camber: -0.5
Total Toe:
1
/
16
”
For a car using power steering car use the following specifications:
Caster: 7
Camber: -0.5
To Next Page
Loading...
