46
www.factoryfive.com 508-291-3443
87-93 Pedal box marked for cutting.
Cut-off the marked area (bottom of the front mount flange) with a hack saw. This is necessary for
steering shaft clearance.
Wiring Harness
Razor knife, electrical tape.
Many people choose to cut down the wiring harness to use only the wires and leads that are
needed. You can save about 20 lbs. by doing this. Be sure to follow the schematics and avoid
cutting circuits you need. Some suggested parts to remove are:
Speaker wires
Radio wiring
Heater wires
Air bag blue boxes and wires
Electronic seat and window controls.
Remote trunk release wires
Not only does this take weight out of the car, it gives additional room behind the dash. Look at the
plugs and compare them to a Chilton’s manual to make sure you are cutting the correct plug before
actually cutting.
To Next Page
Loading...
