339
www.factoryfive.com 508-291-3443
Line up the mesh on the nose and tape them in place to hold them until the silicone dries (usually over
night).
Weatherstripping
Razor knife, tin snips
Secondary body fasteners
Replace any weatherstrip that was damaged during body removal.
Put additional weatherstrip on the frame where gap areas were noted before paint.
The expanding foam weatherstrip is unique in that it has an adhesive side and it expands from ½”
tall to 2” tall over 24 hours. Us this weatherstrip anywhere there were larger gaps or you think
extra weatherstrip is needed.
Final Body Mounting
Using two people, one on each side holding the wheel well and side exhaust recess move towards the
frame from the rear with the back slightly lower than the front.
To Next Page
Loading...
