45
www.factoryfive.com 508-291-3443
Accelerator Pedal
Remove the plastic part of accelerator pedal by pushing out the pin.
Trim the accelerator pedal as shown, just above the plastic pedal support pad. It is possible to mount the
original plastic pedal piece onto the shortened pedal if desired. This can be accomplished by squeezing
the bottom of the trimmed pedal and drilling a hole for the stock pin.
Accelerator pedal modified.
Remove the cruise control switch located under the plastic clutch quadrant on the right side of the pedal
box.
Pedal Box
Marker, hack saw, measuring tape
Mark the mounting face of the 1” up from the bottom of the mounting plate.
To Next Page
Loading...
