263
www.factoryfive.com 508-291-3443
Tail lights
Drill, 1¼” hole saw,
7
/
32
” drill bit, ⅜” socket, flat head screwdriver, razor knife, marker, ruler,
level.
Tail light template, tail lights and hardware.
Be careful with the lenses, they are glass and can break if dropped from a fairly low height.
The rear taillights double as the rear body mount.
There is a plate mounted on the frame to receive the light mount screws.
Use the template in Appendix A to mark the body. Use a level to align the template.
Use a 1¼” hole saw to make the center holes and a
7
/
32
” drill bit for the screw holes.
Take the lights apart and cut the protruding rubber part of the light off as in the picture below.
To Next Page
Loading...
