86
www.factoryfive.com 508-291-3443
If using Rear coil-over shocks, skip the next section.
Spring Perch mounts
½” drill bit, drill, ¾” wrench, ¾” socket, ratchet
Rear spring perches, Mustang springs and rubber isolator mounts
Hold the spring perches up to the frame so the vertical perch mount is in between the 2”x 3” tube and
the vertical frame mount.
Mark the location of the holes on the bottom of the 2”x 3” tube with a marker.
Drill the two hole locations all the way through the tube using a ½” drill bit.
Bolt on the perch using the ½” bolts provided.
To Next Page
Loading...
