237
www.factoryfive.com 508-291-3443
Route the remaining cable back to the calipers and attach. Make sure your routing is out of the way of
any moving parts and the cable has slack to move with the axle.
Pull up on the handle a few times to make sure the self tensioner works and there are no problems with
the cable.
Emergency Brake Boot
⅛” drill bit, drill, Phillips head screwdriver
Interior Trim
Unpack the e-brake boot and a few of trim screws.
Fit the boot over the handle and check the handle actuation. When you are in a position where the boot
clears the handle movement drill through the material into the tunnel and screw it into place.
To Next Page
Loading...
