183
www.factoryfive.com 508-291-3443
Push the brake line adapters through the brackets from the outside in and install the clips that hold them
in place.
If removed, attach the front brake line to the caliper making sure there is a crush-washer on either side of
the fitting. Hand tight is fine on all these for now.
Hard brake lines
From the bottom of the master cylinder, run the 20” brake line forward to the left front brakes.
Using the distribution block diagram below, attach a 60” brake line to the Right Front brake outlet.
Brake Line Routing at Distribution Block
Brake distribution block line routing. Right is towards front of car.
Front of Car
Firewall
From Master Cylinder Front side
From Master Cylinder Rear
To Right
Front Brakes
To Rear Brakes
To Next Page
Loading...
