378
www.factoryfive.com 508-291-3443
Aluminum Splash guards
⅛”,
3
/
16
” drill bit, drill, rivet gun, silicone, caulking gun, ¾” socket, ratchet, extension, marker,
clamps
Secondary body fasteners, packaged aluminum, front wheel and tire
Front Wheel
With the nose up, put a wheel and tire on the front and turn the steering so that the rear of the tire is as
close as possible to the frame.
Clamp the front lower half of the splash guard to the 1”x 1” tube and (from underneath) to the front part
of the body.
Use a level to make sure the surface that will be close to the nose is flat.
To Next Page
Loading...
