269
www.factoryfive.com 508-291-3443
Turn Signal
Drill, 1” hole saw, marker.
Turn signal template, front turn signal light
Only cut the outer lines of the shapes out.
Position templates on the body in their correct locations and tape in place.
Drill the holes with a 1” hole saw.
Test fit a light and adjust if needed. You may have to bend the ground tab slightly or file away a bit at
the hole to make it fit perfectly.
Headlights
Drill,
1
/
8
”, ¼”,
7
/
16
” drill bit, razor knife, masking tape, air saw or jig saw, level.
Headlight template, headlight components,
Cut out the headlight templates from the back of the manual on the outermost diameter and tape them in
the center of the fender with the line level with the ground.
To Next Page
Loading...
