Factory Five Racing Type 65 Coupe - Mass Air Meter, Air Filter and Intake Hose; Engine Ground

219
www.factoryfive.com 508-291-3443
Attach the engine end of the cable sheath to the cable mount on the engine using ⅜” and
7
/
16
” wrenches
and push the cable wiper onto the remaining threads.
Push the ball stud retainer onto the ball stud.
Push/pull the cable into the retainer so that the cable is tight.
Tighten the set screw in the retainer using a
5
/
64
” hex key.
 After driving the car for the first time you may want to adjust the pedal locations for optimum
heal/toe and shoe size differences.
Mass air meter, Air filter and Intake hose
 Drill,
3
/
16
” drill bit, ⅜” socket
 Wire harness mounting hardware, Mustang mass air sensor, mustang intake hose and clamps, air
filter.
 Mass Air Meters are used on 1989 and newer Mustangs.
Turn the Mass Air meter on its side and attach it to the 1” frame tubing above and just forward of the
passenger foot box.
Use kit fasteners to secure bracket.
Attach the intake hose between the mass air meter and the intake.
Attach the air filter to the mass air meter.
Engine Ground
 Sand paper or grinder bit, ½” socket, ratchet,
3
/
16
” hex key
 Mustang Engine ground strap
Clean the powder coating from the hole in the engine mount.