29
www.factoryfive.com 508-291-3443
Remove and discard the front driver’s side plastic wheel well using a 7mm socket to loosen it from the
body.
Disconnect and remove the horns. They are located just forward of the wheel well on the driver’s side
(accessed from the wheel well). Label and mark the connectors with tape.
Interior
Socket set
None.
Remove the seats from the car.
Remove the center consul cover the handle.
Remove the carpet from the car.
Pedal Box, Accelerator Pedal and Clutch Cable
Socket set, wrenches, Phillips head screwdriver, flat head Screwdriver.
Mustang pedal box, accelerator pedal and clutch cable.
The pedal box comes unpainted from Ford. Even on newer cars there is a light coating of rust on
this part. You can clean and paint this part. Take care to avoid painting any of the moving parts.
87-93 Pedal box assembly with switch and throttle pedal.
Remove the clutch cable from the pedal box by releasing the automatic tensioning cog from the toothed
clutch pivot on the pedal box assembly. This is done by pushing on the round end of the mechanism
while moving the cable wheel toward the firewall. The clutch cable can be easily released from the
grooved wheel at this point.
To Next Page
Loading...
