39
www.factoryfive.com 508-291-3443
Remove the bolts and nuts from the lower rear Mustang control arm, where the arms are mounted to the
body/chassis.
Remove the bolts and nuts from the upper Mustang control arm, where the arms are mounted to the
body/chassis.
All of the arms should remain attached to the rear end assembly. Once off, place the bolts back into the
arms and attach nuts so they do not get lost.
Remove the rear end from under the car.
Remove the brackets that secure the quad shocks to the frame.
Use a drill with a ¼” bit to drill out the rivets on the brake bracket, which retain it to the body above the
differential. Keep this bracket for use later.
Fuel filter and connectors
Socket set, small flat head screwdriver, tin snips or razor knife.
Rear fuel lines and fuel filter mount.
Remove the fuel filter and fuel filter mount from the frame.
Disconnect the rear fuel line going from the tank to the filter and store.
Cut the plastic return line hose going to the tank 4” from the tank and store.
Donor Part Preparation
Rear Coil Springs
Hack saw or chop saw
To Next Page
Loading...
