111
www.factoryfive.com 508-291-3443
IRS Rear Coil-Over Shock Assembly
Snap ring pliers, ¾” wrench, ¾” socket, ratchet, ruler, marker, hack saw.
Roadster/Coupe rear shock kit
The rear shocks are pre-valved at the factory in compression and rebound for good street use.
The shocks can be adjusted in rebound as per Koni’s instructions if so desired. The rear springs
are 350lb. Other springs are available for different ride characteristics.
WARNING! Incorrect assembly and maintenance of this part can cause serious injury or death.
Unpack the rear coil-over’s and hardware.
Double check the jam nut under the rod end and bump stop to make sure that it is tight.
To Next Page
Loading...
