Factory Five Racing Type 65 Coupe - Cooling System; Fan Mounting

221
www.factoryfive.com 508-291-3443
 The emissions canister can be mounted to the right side of the engine bay on outside of the 1”
horizontal tubing just behind the mass air meter.
Drill two
3
/
16
” holes through the canister bracket OEM holes. Mount with two #14 screws.
Attach the vent hose from the gas tank to the canister and the hose leading to the engine.
Cooling System

5
/
16
”, ⅜”, ½” Sockets, ⅛”,
7
/
32
”,
5
/
16
” Drill bits, drill, tin snips, hack saw, razor knife, ⅛”,
3
/
16
” hex
key, marker, silicone, rivet gun.
 Fan mounting components, high flow fan, radiator hose kit, radiator mount components,
secondary body fasteners assembly, and aluminum engine bay assembly.
 Make sure the electric fan shroud does not bend/oval or it will cause the fan blades to hit. Do not
lean on the fan shroud while engine is running as this may bend shroud and cause fan blade to hit
fan shroud.
Fan Mounting
Attach the two plastic mount tabs to the top of the electric fan.
Attach the two metal strip mount tabs to the bottom of the electric fan.
Lay the radiator down with the front side up.
Center the fan left to right on the back of the Radiator.
Raise the fan as high as possible so that the fan mount nut can go on the bolt while sitting in the top
radiator flange.