200
www.factoryfive.com 508-291-3443
on the driver’s side at the rear of the trunk area. This can be used if the Coupe fuel cell kit is
used.
Place the battery tray, on top of the trunk floor, with half of the plate on each side of the cross brace
located on the driver side of the trunk.
Mark where the holes line up on the rear facing side of the ¾” tubing.
Drill the holes for the hooks on the rear face of the ¾” tube.
With the bends on the battery tray pointed up, put the hook rods through the tray holes and thread the
washer and nut onto the ends.
Hold the tray up to the drilled holes on the frame and insert the hooks into the holes.
To Next Page
Loading...
