207
www.factoryfive.com 508-291-3443
Place the aluminum sleeve on the bolt with the flange towards the pulley wheel, so that it slides inside
the pulley.
Install the bolt assembly on the A/C bracket (previously drilled in the disassembly section), using the
lock nut provided.
Pull the tension pulley back with a pry bar carefully and install the fan belt. If the belt does not fit using
this routing, check to see if after-market under-drive pulleys have been fitted on any of the accessories
or the crankshaft, if so you may have to also use an after-market belt.
Check the pulley wheel for alignment with the other pulleys so that premature belt wear does not occur.
With one eye, carefully align the front side of the pulley with the front side of the other pulleys. If the
To Next Page
Loading...
