352
www.factoryfive.com 508-291-3443
Use the license plate bracket as a template for the mounting screws. Use a level to make sure the
bracket is level since there are no straight lines on the rear of the car.
Use a ¼” drill bit for the mount screws.
Attach the bracket to the body using the two flat head screws and nuts.
Attach the license plate with the self-tapping screws.
Take the front cover off the license light to use as a template.
Center the light cover over the license plate ½”up from the license plate and mark the mount holes.
Use the ⅛” drill bit for the side mount holes.
Use a 2” hole saw centered between the two mount screws (1
9
/
16
”).
Test fit the light. Enlarge the center hole with a file if necessary.
Assemble the light and attach it to the body using the two supplied screws.
To Next Page
Loading...
