Festo CPX - 2.1 General Instructions on Assembly and Dismantling; Assembling Electric Modules with Plastic Interlinking Blocks; Replacing a Complete Module or Interlinking Block with Tie Rod Interlinking

2. Assembly
2−2
Festo P.BE−CPX−SYS−EN en 0902e
Contents
2. Assembly 2−1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2.1 General instructions on assembly and dismantling 2−3 . . . . . . . . . . . . . . . . . . . .
2.2 Assembling electric modules with plastic interlinking blocks 2−6 . . . . . . . . . . . .
2.2.1 Replacing a
complete module or interlinking block
with tie rod interlinking 2−7 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2.2.2 Increasing or reducing the number of electric
modules 2−10 . . . . . . . . .
2.2.3 Fitting the right−hand end plates with Midi/Maxi valves 2−15 . . . . . . . . .
2.3 Assembling electric modules with metal interlinking blocks 2−17 . . . . . . . . . . . . .
2.3.1 Replacing a complete
module or interlinking block 2−18 . . . . . . . . . . . .
2.4 Fitting the CPX terminal 2−21 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . .
2.4.1 Fitting CPX terminals without pneumatics onto a H−rail 2−21 . . . . . . . . .
2.4.2 Fitting CPX terminals with pneumatics onto an H−rail 2−22 . . . . . . . . . . .
2.4.3 Fitting CPX terminals
with Midi/Maxi pneumatics onto
an H−rail 2−26 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. .
2.4.4 Wall mounting 2−29 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .