Festo SPC200 - Page 31

Contents and general instructions
XXIX
Festo P.BE−SPC200−WIN−PISA−CD−EN en 0901d
2. Read out project (command [Online] [Upload] [Project]).
Enter the project name and confirm. Enter the title and
confirm.
Or set hardware configuration manually
1. Create project (command [File] [New project]) or open
project (command [File] [Open project]).
2. Insert the SPC200 into the project. To do this, select the
icon Hardware" in the project window and
the command
[Insert object] in the menu [Edit]. Then select the entry
SPC200" and confirm.
3. Set the configuration of the SPC200. (Set the basic unit
and modules correctly in the dialogue window SPC200
configuration" and confirm the selection.)
4. Insert hardware (axis or I/O module). To do this, select
the icon for the axis interface
string or for the stepping
motor interface in the project window and select the com
mand [Insert object] in the menu [Edit]. Then select the
desired entry Positioning axis" or I/O module". Then
select the axis used or the desired I/O module. Repeat
this procedure for all the components.