There are a maximum number of acoustic/visual cycles.
When this is reached the system returns to normal op-
eration.
The antilift protection may be turned off by means of the
appropriate key (see “Antilift protection” paragraph over-
leaf).
IMPORTANT The engine stop function is guaranteed by
the Fiat CODE, which is automatically activated when the
ignition key is extracted from the starter device.
TURNING THE ALARM ON
With the doors and bonnets closed and the ignition key
either turned to STOP or removed, point the key with the
remote control towards the vehicle and press and release
the lock button.
Excluding some markets, the system produces an acous-
tic warning (beep) and enables door locking.
The switching on of the alarm is preceded by an self-di-
agnosis stage: if a fault is detected, the system produces
another acoustic signal.
In this case, turn the alarm off by pressing the ‘release
doors/release load compartment’ button, check the doors
and bonnet are properly closed and turn the alarm back
on by pressing the lock button.
ELECTRONIC ALARM
(for versions/markets where provided)
The alarm, in addition to all the remote control functions
described previously, is controlled by the receiver locat-
ed under the dashboard near the fuse box.
ALARM TRIPPING
The alarm intervenes in the following cases:
❒
when one of the doors or bonnet is opened illegiti-
mately (perimeter protection);
❒
when the ignition system is started up (ignition key
rotated to MAR);
❒
when the battery cables are cut;
❒
when the vehicle is lifted or tilted.
Depending on the market, the activation of the alarm caus-
es the activation of the siren and the direction indicators
(for about 26 seconds). Alarm tripping and the number
of cycles depend on the sales market.
10
DASHBOARD
AND CONTROLS
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
INDEX
001-036 DUCATO LUM EN 11-02-2010 13:53 Pagina 10
To Next Page
Loading...
