Fiat Ducato - Setting the Clock (Set Time); Trip B On;Off (Tripb Data)

29
DASHBOARD
AND CONTROLS
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
INDEX
– when accessing the “Hour” submenu: briefly press button
MODE: the display shows the “hours” flashing;
– press button ▲ or ▼ to adjust;
– briefly press button MODE: “minutes”starts flashing on
the display;
– press button
▲ or ▼ to adjust;
– when accessing the “Format” submenu: briefly press but-
ton MODE : the previously set display format will flash
on the display;
– press button
▲ or ▼ to select “24h” or “12h”.
When you have made the required settings, briefly press
the MODE button to go back to the submenu screen or
hold the button down to go back to the main menu screen
without storing the new settings.
– press the MODE button again for a while to return to
the standard screen or to the main menu according to
where you are in the menu.
Trip B On/Off (tripB data)
This function may be used to activate (On) or deactivate
(Off) the Trip B (partial trip).
For further information see the “Trip computer” paragraph.
Proceed as follows to switch the function on and off:
– briefly press button MODE: ON or OFF flashes on the
display (according to the previous setting);
– press button
▲ or ▼ to select;
– press the MODE button briefly to return to the menu
screen or press the button for longer to return to the stan-
dard screen without memorizing.
Setting the clock (Set time)
This function enables to set the clock through two sub-
menus: “Time” and “Format”.
To carry out the adjustment, proceed as follows:
– briefly press the MODE button and two submenus (Time
and Format) are displayed;
– press button
▲ or ▼ to move between the two sub-
menus;
– once you have selected a submenu to amend, press
MODE briefly;
001-036 DUCATO LUM EN 11-02-2010 13:53 Pagina 29