Fiat Ducato - Setting the Clock (Hour); Setting the Speed Limit (SPEED)

21
DASHBOARD
AND CONTROLS
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
INDEX
Setting the clock (Hour)
This function is used to set the clock.
To set the required unit proceed as follows:
– briefly press button MODE: the display shows the
“hours” flashing;
– press button ▲ or ▼ to adjust;
– briefly press button MODE: “minutes”starts flashing on
the display;
– press button ▲ or ▼ to adjust;
– press the MODE button briefly to return to the menu
screen or press the button for longer to return to the stan-
dard screen without memorizing.
Setting the speed limit (SPEED)
With this function it is possible to set the vehicle speed
limit (km/h or mph); when this limit is exceeded the driv-
er is immediately alerted (see section “Warning lights and
messages”).
To set the desired speed limit, proceed as follows:
– briefly press button MODE, the display will show the
wording (SPEED) and the unit (km/h) or (mph) previous-
ly set;
– press button ▲ or ▼ to select activation (On) or deac-
tivation (
OFF) of the speed limit;
– if the function has been activated (On), press buttons
▲ or ▼ to select the required speed limit and then press
MODE to confirm.
NOTE The speed may be set in the range from 30 to
200 km/h, or from 20 to 125 mph according to the pre-
viously chosen unit (see “Setting the distance unit”) de-
scribed below. The setting will increase/decrease by five
units each time button ▲/▼ is pressed. Hold down but-
ton ▲/▼ to increase/decrease the setting rapidly. Com-
plete the setting by briefly pressing the button when you
approach the required setting.
– press the MODE button briefly to return to the menu
screen or press the button for longer to return to the stan-
dard screen without memorizing.
001-036 DUCATO LUM EN 11-02-2010 13:53 Pagina 21