INCREASING THE MEMORISED SPEED
This can be done in two ways:
❒
by pressing the accelerator and then memorising the
new speed reached;
or
❒
by moving the lever upwards (+).
Each movement of the stalk will correspond to an increase
in speed of about 1 km/h, while keeping the stalk held up-
wards will continuously increase the speed.
REDUCING THE MEMORISED SPEED
This can be done in two ways:
❒
by turning the device off and then storing a new speed;
or
❒
by moving the lever downwards (–) until reaching the
new speed which will be memorised automatically.
Each movement of the stalk will correspond to a reduc-
tion in speed of about 1 km/h, while keeping the stalk held
downwards will continuously reduce the speed.
When travelling downhill with the device engaged, the ve-
hicle speed may slightly exceed the memorised one.
When the device is activated the warning light
Ü
comes
on together with the relevant message on the instrument
panel.
STORING VEHICLE SPEED
Proceed as follows:
❒
turn control Ax to ON and press the accelerator pedal
so that the vehicle reaches the desired speed;
❒
move the levers upwards (+) for at least one second,
then release it. The car speed is memorised and it is
therefore possible to release the accelerator pedal.
If necessary (when overtaking for instance) acceleration is
possible by simply pressing the accelerator pedal: releas-
ing the accelerator pedal, the car will return to the speed
memorised previously.
RESTORING THE MEMORISED SPEED
If the device has been switched off, for example by press-
ing the brake or clutch pedal, the memorised speed can
be restored as follows:
❒
accelerate gradually until reaching a speed approach-
ing the memorised speed;
❒
engage the gear selected at the time of speed memo-
rising;
❒
press the button RES B.
79
DASHBOARD
AND CONTROLS
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
INDEX
037-122 DUCATO LUM EN 11-02-2010 14:26 Pagina 79
To Next Page
Loading...
